S13/180sx rear traction arm weld in reinforcement plates Spares

S13/180sx rear traction arm weld in reinforcement plates SparesThe GKTech weld in traction arm plates have been designed to help brace the OEM traction arms. As the value of these vehicles increases we've seen the need to refurbish and improve some of the OEM parts rather than completly replace. Nissan obviously felt it was a good idea to reinforce the traction arms as they did update the traction arms with plates (similar to these) in the later model S chassis'. CAD Designed CNC Laser Cut from 2mm C30 steel

270 kg BEARING MATERIAL BEARING MATERIAL STAINLESS STEEL STAINLESS STEEL LUBRICATION LUBRICATION PTFE lined PTFE lined

after an update - these bushes can also be used to replace the OEM rubber bushes for camber and traction arms (Subframe side)

If you wanted the deep dished suede steering wheels they can be seen HERE

where the spring is incorporated into the coilover body

- Replacement part for Nissan part number: 11220-JK30A

The GKTECH high misalignment tie rods have 64 degrees of misalignment and also up to 15mm of bump steer correction built in

The GKTECH high tensile 4130 zinc coated tie rod extender conversions screw on to the end of M16 tie rods and allow the tie rods to travel further into the steering rack which creates more steering lock

meaning it can be fitted and removed with no permanent modifications other than the trimming of the factory lock stop if you wish to

1mm (Nissan)Available in a range of different sizes to suit different wheel center bores

5mm which helps to correct the roll center on lowered vehicles

00” apart

- All new stainless steel clamps