R33/R34 Skyline Tubular Caster Arms REINFORCEMENT PLATES

R33/R34 Skyline Tubular Caster Arms REINFORCEMENT PLATESThe GKTECH Caster arms (aka tension rods) allow adjustment in your Skylines castor to bring the wheels forward and increase steering response. In general, the more caster the better. Allowing sharper turn in and faster return to the straight position when letting go of the wheel. Our arms feature high quality 5 8" Teflon lined pillow ball rod ends which eliminate the flex found in factory rubber bushing offering a more direct and predictable feel.

NOTE#3: If you are intending on running the rear LCA's shorter than the OEM arms please ensure that your upper arms have adequate adjustment based on your setup

- V5 arms include offset bush spacers for even more clearance

the lower arm will now be pointing slightly upwards which will lower the roll center (which is the point at which the car rolls about) this gives the car leverage and makes it easier for the car to roll from side to side

- Replacement part for Nissan part numbers: 11320-CD000 and 11320-RRZ30

5" pipe and includes the 2x custom bends to run through the factory radiator support (without the need for cutting)

The GKTECH 350z rear Brembo to S chassis/R32/R33 weld on caliper brackets allows the fitment of a 350z rear Brembo caliper on the OEM cast steel knuckle

When installing the fan ensure that there is at least 10-20mm's clearance between the fan and anything around it

2019 at 4:29pm PDT

Sold as a pair (2pcs) for a single side

does not fit VERT

Inside mount = mounts inside the center console itself

NOTE#2: 5mm